Medium Duty Floor Cable Protector with Hazard Stripe - FC83H/9M
Ideal for up to 3x 8mm diameter cables, this versatile Cable Protector is supplied with connector pins so it can be cut to shorten, then reconnected or combined
with other lengths to make longer runs.
The hazard stripe gives greater visibility to pedestrians.
Supplied with connector pins, so lengths can be joined to make longer runs.
- Ideal for areas with regular foot traffic
- Protect cables, and address a common cause of trips and falls
- Prevent cable insulation damage/electrocution and risk of broken conductor strands
- 30mm x 10mm cavity
- 9m in length
- Ribbed non-slip base, pre-split rear for ease of use
- Flexible PVC - Neat tapered design, lengths uncoil to lay flat
- No sharp kerb-effect, pedestrian friendly
- Fully safety tested and certified to BS EN 60670-1:2005
Technical Specification
- Produced from flexible PVC
• Flexible to uncoil and lay flat, no adhesive tapes required
• Abrasion resistant
- Popular usage
• To protect cords across floors, and eliminate trip hazards
• For health & safety
• Ideal for areas with regular foot traffic
- Quality approvals: BSEN 60670-1:2005 PART 1
- UV stabilised: Yes
- Cavity size: 30x10mm for up to 3x 8mm (outer diameter) cables
- Dimensions: 83mm Width - Available as 1.8m or 9m length
- Weight: 1.8m = 1.4kg Boxed 9m = 6.5kg
- Colour: Black, with yellow hazard stripes
- Supplied with 2 connector rods
• To push-in, pull apart
• Length 10cm each
• Ribbed for friction fit
• To make longer lengths
• PVC, can bend & flex
- Packaging: usually supplied coiled in cardboard box
- Recyclability: Yes